Bexley UFH flooring fitters — heat you can actually feel
Underfloor heating only works if the floor above it is spec'd correctly. Wrong underlay, wrong plank thickness or a sealed perimeter and the room stays cold. In Bexley we fit LVT, laminate and engineered wood rated for UFH, on underlay under 1.0 tog, with a proper expansion gap so the boards can move through the heating cycle.
What flooring over underfloor heating in Bexley actually involves
Underfloor heating only works if the floor above it is spec'd correctly. Wrong underlay, wrong plank thickness or a sealed perimeter and the room stays cold. In Bexley we fit LVT, laminate and engineered wood rated for UFH, on underlay under 1.0 tog, with a proper expansion gap so the boards can move through the heating cycle.
Victorian cottages often have suspended timber over ventilated voids — careful nailing only.
- Only UFH-rated LVT, laminate and engineered wood used
- Underlay kept below 1.0 tog so heat actually reaches the room
- Perimeter expansion gap sized for full UFH cycle
- Manifold and probes protected during fit
What we check first on a Bexley lvt job
- Bexley subfloor reality
Victorian cottages often have suspended timber over ventilated voids — careful nailing only.
- Pattern direction
Plank run follows the longest sightline; in narrow Bexley hallways that means front-door to kitchen.
- Door undercut
We trim doors on the day so they swing cleanly over glue-down LVT — no scraping, no callbacks.
“Always so helpful and professional, carpets are good quality and stay looking nice even with a family and a dog. Would highly recommend.” — Katie Rial, verified Google review
Bottom line: a UFH floor is only as good as the plank and underlay above it. We spec both for your Bexley system.
Postcodes: DA5 · Routes: the A2 and Old Bexley Lane · Common build: Victorian cottages.
Covering Old Bexley, North Cray, Bexley village.
Relevant finishes for flooring over underfloor heating
Flooring Over Underfloor Heating in Bexley — common questions
Yes — but only UFH-rated boards (usually 8mm HDF core, marked on the pack) with an underlay under 1.0 tog. Standard 12mm click laminate will insulate your UFH and cost you heat.
For heat transfer, yes — 4–5mm LVT sits directly on the screed with a very low thermal resistance. Most new Bexley kitchens over UFH now go LVT for that reason.
55°C at the plank, 27°C at the floor surface — the industry standard. Above that, planks cup and joints open. We commission with your plumber so we know the ramp-up.
Yes — dropped to 15–18°C for 48 hours before, off during the fit, then ramped back up 2°C per day. We give you the schedule in writing after the Bexley survey.