Kidbrooke UFH flooring fitters — heat you can actually feel
Wet UFH in a berkeley homes new-builds extension near the A2 and Rochester Way and electric mats in a Kidbrooke Village bathroom are different jobs. We spec each — plank type, adhesive, underlay — from the manifold spec you already have. Nothing voids your UFH warranty.
What flooring over underfloor heating in Kidbrooke actually involves
Wet UFH in a berkeley homes new-builds extension near the A2 and Rochester Way and electric mats in a Kidbrooke Village bathroom are different jobs. We spec each — plank type, adhesive, underlay — from the manifold spec you already have. Nothing voids your UFH warranty.
New-build screed is LVT-ready; 1930s semis need ply over the pine boards.
- Only UFH-rated LVT, laminate and engineered wood used
- Underlay kept below 1.0 tog so heat actually reaches the room
- Perimeter expansion gap sized for full UFH cycle
- Manifold and probes protected during fit
Before we quote a lvt job in Kidbrooke
- Subfloor flatness
LVT shows every bump — berkeley homes new-builds subfloors in Kidbrooke almost always need ply or self-levelling screed first.
- Door undercut
We trim doors on the day so they swing cleanly over glue-down LVT — no scraping, no callbacks.
- Pattern direction
Plank run follows the longest sightline; in narrow Kidbrooke hallways that means front-door to kitchen.
"Kitchen extension in Kidbrooke Village, wet UFH under 4mm LVT — floor genuinely warm within a day." — Kidbrooke customer
In short — Kidbrooke UFH flooring from £38/m² fitted, using UFH-rated planks and low-tog underlay so the heat actually reaches the room.
Postcodes: SE3 · Routes: the A2 and Rochester Way · Common build: Berkeley Homes new-builds.
Covering Kidbrooke Village, Ferrier estate footprint, Weigall Road.
Flooring Over Underfloor Heating jobs we've finished nearby
Flooring Over Underfloor Heating in Kidbrooke — common questions
Yes — but only UFH-rated boards (usually 8mm HDF core, marked on the pack) with an underlay under 1.0 tog. Standard 12mm click laminate will insulate your UFH and cost you heat.
For heat transfer, yes — 4–5mm LVT sits directly on the screed with a very low thermal resistance. Most new Kidbrooke kitchens over UFH now go LVT for that reason.
55°C at the plank, 27°C at the floor surface — the industry standard. Above that, planks cup and joints open. We commission with your plumber so we know the ramp-up.
Yes — dropped to 15–18°C for 48 hours before, off during the fit, then ramped back up 2°C per day. We give you the schedule in writing after the Kidbrooke survey.