Fit new flooring over your Plumstead UFH system
Most Plumstead UFH complaints come from the flooring, not the boiler. A 12mm plank with 3mm foam is doing the wrong job. We use 4–5mm LVT or 8mm UFH-rated laminate over ≤1.0 tog underlay so heat reaches Victorian and Edwardian terraces with post-war infill feet — not the subfloor.
What flooring over underfloor heating in Plumstead actually involves
Most Plumstead UFH complaints come from the flooring, not the boiler. A 12mm plank with 3mm foam is doing the wrong job. We use 4–5mm LVT or 8mm UFH-rated laminate over ≤1.0 tog underlay so heat reaches Victorian and Edwardian terraces with post-war infill feet — not the subfloor.
Original pine boards on the terraces — ply overlay before LVT is standard.
- Only UFH-rated LVT, laminate and engineered wood used
- Underlay kept below 1.0 tog so heat actually reaches the room
- Perimeter expansion gap sized for full UFH cycle
- Manifold and probes protected during fit
Plumstead lvt — the details that matter
- Subfloor flatness
LVT shows every bump — victorian and edwardian terraces subfloors in Plumstead almost always need ply or self-levelling screed first.
- Door undercut
We trim doors on the day so they swing cleanly over glue-down LVT — no scraping, no callbacks.
- Pattern direction
Plank run follows the longest sightline; in narrow Plumstead hallways that means front-door to kitchen.
"Swapped a cold laminate for UFH-rated planks — same heating, 4°C warmer floor." — SE18 homeowner
Recap — LVT, laminate and engineered wood fitted over UFH across SE18, with warranty-safe adhesives and expansion gaps.
Postcodes: SE18 · Routes: the A206 · Common build: Victorian and Edwardian terraces.
Covering Plumstead Common, The Slade, Winn's Common.
Flooring Over Underfloor Heating jobs we've finished nearby
Flooring Over Underfloor Heating in Plumstead — common questions
Yes — but only UFH-rated boards (usually 8mm HDF core, marked on the pack) with an underlay under 1.0 tog. Standard 12mm click laminate will insulate your UFH and cost you heat.
For heat transfer, yes — 4–5mm LVT sits directly on the screed with a very low thermal resistance. Most new Plumstead kitchens over UFH now go LVT for that reason.
55°C at the plank, 27°C at the floor surface — the industry standard. Above that, planks cup and joints open. We commission with your plumber so we know the ramp-up.
Yes — dropped to 15–18°C for 48 hours before, off during the fit, then ramped back up 2°C per day. We give you the schedule in writing after the Plumstead survey.