Flooring over underfloor heating in Welling
Wet UFH in a 1930s semis extension near the A207 (Bellegrove Road) and electric mats in a East Wickham bathroom are different jobs. We spec each — plank type, adhesive, underlay — from the manifold spec you already have. Nothing voids your UFH warranty.
What flooring over underfloor heating in Welling actually involves
Wet UFH in a 1930s semis extension near the A207 (Bellegrove Road) and electric mats in a East Wickham bathroom are different jobs. We spec each — plank type, adhesive, underlay — from the manifold spec you already have. Nothing voids your UFH warranty.
Falconwood bungalows often sit on solid concrete — minimal prep, ideal for LVT.
Three things that decide a lvt fit in Welling
- Subfloor flatness
LVT shows every bump — 1930s semis subfloors in Welling almost always need ply or self-levelling screed first.
- Door undercut
We trim doors on the day so they swing cleanly over glue-down LVT — no scraping, no callbacks.
- Pattern direction
Plank run follows the longest sightline; in narrow Welling hallways that means front-door to kitchen.
- Only UFH-rated LVT, laminate and engineered wood used
- Underlay kept below 1.0 tog so heat actually reaches the room
- Perimeter expansion gap sized for full UFH cycle
- Manifold and probes protected during fit
Recap — LVT, laminate and engineered wood fitted over UFH across DA16, with warranty-safe adhesives and expansion gaps.
"Kitchen extension in East Wickham, wet UFH under 4mm LVT — floor genuinely warm within a day." — Welling customer
Postcodes: DA16 · Routes: the A207 (Bellegrove Road) · Common build: 1930s semis.
Covering East Wickham, Falconwood, Danson.
Flooring Over Underfloor Heating jobs we've finished nearby
Flooring Over Underfloor Heating in Welling — common questions
Yes — but only UFH-rated boards (usually 8mm HDF core, marked on the pack) with an underlay under 1.0 tog. Standard 12mm click laminate will insulate your UFH and cost you heat.
For heat transfer, yes — 4–5mm LVT sits directly on the screed with a very low thermal resistance. Most new Welling kitchens over UFH now go LVT for that reason.
55°C at the plank, 27°C at the floor surface — the industry standard. Above that, planks cup and joints open. We commission with your plumber so we know the ramp-up.
Yes — dropped to 15–18°C for 48 hours before, off during the fit, then ramped back up 2°C per day. We give you the schedule in writing after the Welling survey.