Flooring over underfloor heating in Barnehurst
Most Barnehurst UFH complaints come from the flooring, not the boiler. A 12mm plank with 3mm foam is doing the wrong job. We use 4–5mm LVT or 8mm UFH-rated laminate over ≤1.0 tog underlay so heat reaches Almost entirely 1930s bay-fronted semis feet — not the subfloor.
What flooring over underfloor heating in Barnehurst actually involves
Most Barnehurst UFH complaints come from the flooring, not the boiler. A 12mm plank with 3mm foam is doing the wrong job. We use 4–5mm LVT or 8mm UFH-rated laminate over ≤1.0 tog underlay so heat reaches Almost entirely 1930s bay-fronted semis feet — not the subfloor.
1930s pine floorboards throughout — always ply-overlaid before LVT or vinyl.
Three things that decide a lvt fit in Barnehurst
- Subfloor flatness
LVT shows every bump — 1930s bay-fronted semis subfloors in Barnehurst almost always need ply or self-levelling screed first.
- Door undercut
We trim doors on the day so they swing cleanly over glue-down LVT — no scraping, no callbacks.
- Pattern direction
Plank run follows the longest sightline; in narrow Barnehurst hallways that means front-door to kitchen.
- Only UFH-rated LVT, laminate and engineered wood used
- Underlay kept below 1.0 tog so heat actually reaches the room
- Perimeter expansion gap sized for full UFH cycle
- Manifold and probes protected during fit
In short — Barnehurst UFH flooring from £38/m² fitted, using UFH-rated planks and low-tog underlay so the heat actually reaches the room.
“Responsiveness, Punctuality, Quality, Professionalism, Value — all 5 stars.” — Sam Condon, verified Google review
Postcodes: DA7 · Routes: the A2 and Mayplace Road · Common build: 1930s bay-fronted semis.
Covering Mayplace, Colyers, May Place.
Relevant finishes for flooring over underfloor heating
Flooring Over Underfloor Heating in Barnehurst — common questions
Yes — but only UFH-rated boards (usually 8mm HDF core, marked on the pack) with an underlay under 1.0 tog. Standard 12mm click laminate will insulate your UFH and cost you heat.
For heat transfer, yes — 4–5mm LVT sits directly on the screed with a very low thermal resistance. Most new Barnehurst kitchens over UFH now go LVT for that reason.
55°C at the plank, 27°C at the floor surface — the industry standard. Above that, planks cup and joints open. We commission with your plumber so we know the ramp-up.
Yes — dropped to 15–18°C for 48 hours before, off during the fit, then ramped back up 2°C per day. We give you the schedule in writing after the Barnehurst survey.